DT 72″ Snap-In Filler for PHK95 and PHSQK95 Series Headers

Snap-In Filler Made for PHK95 and PHSQK95 Headers, Satin Brass

This 72-inch snap-in filler is built to fit the DT PHK95 and PHSQK95 series headers and comes finished in satin brass. It carries item number PHKHF72SB and presses into the header channel to close the gap and give the top rail a finished face.

Because it snaps in rather than needing separate fasteners, it speeds up install and keeps a clean line along the header. Matching it to the PHK95 or PHSQK95 header means the profile lines up correctly instead of leaving a mismatched edge.

Key Product Features

• Snap-in filler, 72 inches long
• Made for PHK95 and PHSQK95 series headers
• Satin brass finish
• Item number PHKHF72SB
• No separate fasteners needed
• Compares to S1F720PNEXT

Installation Notes

Line up the filler with the header channel and press it in along its length until it seats. Trim the 72-inch piece to match your header run before snapping it in.

Ordering and Shipping

Listed on page 100 of the FSH24 catalog. Sign in to see current pricing.